ADVANCED STORAGE CONCEPTS ASC-88 Card Type Hard drive controller card Hard Drives supported Up to 7 SCSI devices Floppy drives supported None Data Bus 8-bit ISA Card Size Quarter-length, full-height card [Image] CONNECTIONS Function Location Function Location 50-pin SCSI CN1 Terminating RN1-RN3 connector - resistors external USER CONFIGURABLE SETTINGS Function Location Setting » Power to external pull-ups BUS-PWR Pins 1 & 2 disabled closed +5V power to external pull-ups BUS-PWR Pins 3 & 4 enabled closed SEGMENT ADDRESS SELECTION Setting A16 A15 A14 C000h Pins 1 & 2 closed Pins 1 & 2 closed Pins 1 & 2 closed C400h Pins 1 & 2 closed Pins 1 & 2 closed Pins 2 & 3 closed C800h Pins 1 & 2 closed Pins 2 & 3 closed Pins 1 & 2 closed CC00h Pins 1 & 2 closed Pins 2 & 3 closed Pins 2 & 3 closed D000h Pins 2 & 3 closed Pins 1 & 2 closed Pins 1 & 2 closed D400h Pins 2 & 3 closed Pins 1 & 2 closed Pins 2 & 3 closed D800h Pins 2 & 3 closed Pins 2 & 3 closed Pins 1 & 2 closed DC00h Pins 2 & 3 closed Pins 2 & 3 closed Pins 2 & 3 closed Note: A total of 8 segment address settings are available. The settings are a binary representation of the hexidecimal segment addresses. A16 is the Most Significant Bit and switch A14 is the Least Significant Bit. The jumpers have the following decimal values: A16=1000h, A15=800h, and A14=400h. Turn off the jumpers by closing pins 1 & 2 and turn on the jumpers by closing pins 2 & 3. Add the values of the jumpers with pins 2 & 3 closed to obtain the correct memory address. (Pins 1 & 2 = Off, Pins 2 & 3 = On.)